Roundness Measuring Instruments Roundness Measuring Instruments ,Roundness Tester,Roundness Measuring Machine,Instrument Used To Measure Roundness Zhejiang dexun instrument technology co., ltd , https://www.dexunmeasuring.com
2. Before use, you must carefully check whether the rotating part is flexible and collision-free, whether the adjustment mechanism is normal, and whether the safety facilities are complete and effective; to ensure that there is no debris in the machine, lubricate the lubrication parts.
3. Before the machine is turned on, clean up the work site. Do not put any debris that is not related to threshing. Prevent children from playing on the edge of the site to avoid accidents.
4. The feeding should be continuous and uniform. When the operation is completed, the machine can not be stopped immediately. The machine can only be stopped after all the corn sticks inside are empty. When a blockage occurs, it must be shut down for processing. There can be no luck.
5. The connection of the transmission belt should be firm; it is forbidden to pick up the belt or touch any of the objects in the driving position while the machine is running.
6. The transmission ratio between the supporting power and the thresher shall meet the requirements so as to avoid personal injury accidents caused by damaged parts or loose fasteners due to excessively high threshing speed and violent vibration.
7. Can not work for a long time, the general work of about 8 hours to stop the inspection, adjustment and lubrication, to prevent serious friction caused by wear, heat or deformation.
8. When using a diesel engine as a power source, wear a fire shield on the exhaust pipe to prevent fire.
9. During the job process, the working status of the machine is identified by voice. If there is a failure during the operation, it should be stopped and then repaired and adjusted.
10. Always inspect the components and replace and repair them in time if a safety hazard is found.
Corn thresher safe use ten attention
1. Because the working environment of the thresher is very bad, it is necessary to educate the personnel participating in the operation in advance to make sure that they understand the operating procedures and safety knowledge. Such as the sleeves should be tight, should wear masks and protective glasses.