The correct use of Xulang Almighty Crusher

I bought a good all-round pulverizer. If it is not used correctly, it will not only shorten the service life of the omnipotent pulverizer, but also affect the work efficiency, which will result in half the effort.

1. When working on the all-round pulverizer, it should be fixed on hard wood or cement.

2. After the installation of the all-round pulverizer, check the fastening condition of each fastener. If it is loose, it must be tightened.

3. Check if the belt tightness is appropriate and whether the motor shaft and the pulverizer shaft are parallel.

4. Before starting the all-round pulverizer, first turn the rotor by hand to check whether the teeth, hammer and rotor are running flexibly and reliably. There is no collision in the shell. Whether the rotation direction of the rotor is consistent with the direction indicated by the arrow on the machine, the motor and Is the powder machine lubricated?

5. Do not change the pulleys casually, in case the rotation speed is too high, the explosion chamber will explode, or the rotation speed will be too low, which will affect the working efficiency.

6. After the start of the all-round smashing station, it will be idling for 2-3 minutes. After no abnormal phenomenon, it will be fed again.

7, at work should pay attention to the operation of the pulverizer at all times, the feeding should be even, to prevent blocking the car, do not overload the machine for a long time. If vibration, noise, high temperature of the bearing and the body, and external spraying are found, stop the test immediately and continue working after troubleshooting.

8. Clean the iron removal device in time to prevent copper, iron, and other materials from entering the crushing chamber and causing accidents.

In addition to the correct use of the all-round pulverizer, the necessary daily maintenance and maintenance of the all-round pulverizer should be carried out to prevent the occurrence of pulverizer failure and prolong its service life.

1. Screen repair and replacement screens are made of thin steel or iron punched holes. When the screen is worn or broken by foreign matter, if the damage is not large, it can be repaired by riveting or soldering; if the area is damaged, the new screen should be replaced. When installing the screen, the burr side of the screen hole should face inward, the glossy side should be facing outward, and the screen and screen frame should be tightly attached. When the ring screen is installed, the lap of the lap should be in the direction of rotation to prevent the material from getting stuck at the lap joint.

2. Lubrication and replacement of the bearing The grinding machine should be cleaned after every 300 hours of operation. If the bearing is oil lubricated, it is advisable to fill the bearing housing clearance by 1/3 when adding new oil, and the maximum is not more than 1/2. Just tighten the capped oil cup cover a little before operation. When the crusher bearing is seriously worn or damaged, it should be replaced in time, and pay attention to strengthen lubrication; if using tapered roller bearing, pay attention to check the axial spacing of the bearing to keep it 0.2-0.4 mm. If there is discomfort, increase or decrease Adjust the paper pad at the bearing cover.